PassMyTest

CDL Air Brakes Practice Test

Practice the air brakes knowledge test: compressor cut-in and cut-out, warning pressures, spring brakes, leakage limits, brake lag and safe downhill braking.

Loading your test…

Air brake numbers to know

Governor cut-outAbout 125 psi
Governor cut-inAbout 100 psi
Low-pressure warningBefore pressure falls below 60 psi
Spring brakes applyBetween 20 and 45 psi
Safety relief valveAbout 150 psi
Build-up (dual system)85 to 100 psi within 45 seconds
Static leakage (brakes released)Under 2 psi/min single, 3 psi/min combination
Applied leakageUnder 3 psi/min single, 4 psi/min combination

If you skip or fail the air brakes test, your CDL will carry a restriction that keeps you from driving commercial vehicles with full air brakes.

All 25 questions and answers

Show all 25 air brakes questions and answers
  1. Air brake systems are made up of three braking systems. They are:Answer: Service, parking and emergency brakesThe service brake slows and stops you, the parking brake holds the vehicle, and the emergency system stops you if the service system fails.
  2. The air compressor governor stops the compressor from pumping air (cut-out) at about:Answer: 125 psiThe governor stops the compressor at about 125 psi and restarts it (cut-in) at about 100 psi.
  3. The air compressor should start pumping again (cut-in) at about:Answer: 100 psiCut-in is around 100 psi; cut-out is around 125 psi.
  4. The low air pressure warning must come on before tank pressure falls below:Answer: 60 psiA warning light or buzzer must activate before air pressure drops below 60 psi.
  5. In most vehicles, the spring brakes come on automatically when air pressure drops to between:Answer: 20 and 45 psiSpring brakes apply on their own when pressure falls into the 20 to 45 psi range.
  6. The air tank safety relief valve is usually set to open at about:Answer: 150 psiThe safety valve protects the system from too much pressure, usually opening at 150 psi.
  7. Air tanks should be drained to remove:Answer: Water and compressor oilWater and oil collect in the tanks and can freeze or damage brakes.
  8. An alcohol evaporator is used in some air brake systems to:Answer: Reduce the risk of ice in air valves in cold weatherAlcohol added to the air lowers the chance of moisture freezing in the system.
  9. With the engine at fast idle, a dual air system should build pressure from 85 to 100 psi within:Answer: 45 secondsIf pressure builds too slowly, the system may have a problem.
  10. With the engine off and brakes released, air loss in a single vehicle should be no more than:Answer: 2 psi in one minuteStatic leakage limits: 2 psi per minute for single vehicles, 3 psi per minute for combinations.
  11. With the engine off and the service brakes fully applied, a combination vehicle should lose no more than:Answer: 4 psi in one minuteApplied leakage limits: 3 psi per minute for single vehicles, 4 psi per minute for combinations.
  12. When you can pull a brake pushrod more than about 1 inch by hand where it attaches to the slack adjuster, the brake:Answer: Probably needs adjustmentExcess slack means the brake is out of adjustment and will not stop the vehicle well.
  13. 'Brake lag' in an air brake system is:Answer: The time it takes air to flow to the brakes after you press the pedalBrake lag adds distance to your stop, so air-braked vehicles need more stopping distance.
  14. Total stopping distance for an air-braked vehicle is made up of perception distance, reaction distance, braking distance and:Answer: Brake lag distanceAir brakes add brake lag distance to the usual stopping distance.
  15. On a long downgrade with a 40 mph safe speed, you should use 'snub braking' by:Answer: Braking until you are about 5 mph below the safe speed, then releasingApply the brakes firmly enough to slow to about 35 mph, then release. Repeat when you reach 40 mph again.
  16. If the low air pressure warning comes on while driving, you should:Answer: Stop safely as soon as possibleLow pressure can lead to spring brakes locking. Stop and park safely while you still have control.
  17. You should not use the parking brakes when:Answer: The brakes are very hot or wet in freezing weatherHot brakes can be damaged and wet brakes can freeze. Use wheel chocks instead.
  18. To test the service brakes before driving, you should:Answer: Move forward slowly (about 5 mph) and apply the brakes firmlyA firm stop at low speed shows whether the vehicle pulls to one side or stops poorly.
  19. An air brake 'wig wag' is a:Answer: Low-pressure warning device that drops into viewA wig wag is a mechanical arm that drops into the driver's view when air pressure is low.
  20. Truck tractors with air brakes built on or after March 1, 1997 are required to have:Answer: Anti-lock brakes (ABS)Federal rules require ABS on air-braked tractors built on or after March 1, 1997.
  21. With anti-lock brakes, you should brake:Answer: The same way you normally would, with steady pressureABS keeps wheels from locking. Brake normally and keep steering.
  22. The supply pressure gauge shows:Answer: How much pressure is in the air tanksThe supply pressure gauge shows the air pressure available in the tanks.
  23. The application pressure gauge shows:Answer: How much air pressure you are applying to the brakesIf you need more and more pressure to hold speed, your brakes may be fading.
  24. The air compressor is driven by:Answer: The engine, through gears or a beltThe compressor runs off the engine via gears or a V-belt.
  25. Why should you drain the air tanks completely?Answer: Water and oil left in the tanks can cause brake failureMoisture and oil can damage the system and freeze in cold weather.